the Finale

 OBJECTIFY RESPONCE




MESH MASHUP



PAPERCRAFT


3D PRINTING

Comments

Post a Comment

Popular posts from this blog

Project 1: Objectified

Image
  My object was inspired by the section of the Documentary Objectified where they talked about making potato peelers accessible to people with arthritis. It made me think of the Nintendo switch controllers and how they could be improved and easier to use. First I gave the Controller more depth, making it easier to wrap your hand around. I also Coloured the buttons, so its even  easier to distinguish them from each other. I made the stick bigger so it can have a deeper feel to it, as well as the trigger. because the real ones are clicky and don't have a deep pull. finally, the controllers are quiet small because its made for kids. so now there's an attachable part that goes around the bottom and side to essentially make the controller bigger, as well as distance the base of your thumb it so you don't have to bend your thumb at 90 degrees to use the stick, but can rest on it more naturally. The documentary really inspires me to think of how the design of any object is really ...
Read more

PaperCraft Final

Image
  This is what I have so far. The arm and head are posable While I was working on the project I found that magnets are really good to help hold tabs in, as long as you have a way to get them out afterwards. for cutting black paper I printed on white paper then connected with magnets and cut both. Here you can see that the hat can detach like a normal minifigure. I made the head here slightly differently than I made it in the prototype, and I found that the order you glue things can make a big difference and make it easier. I also found that cloth pins work to hold parts in place. In conclusion even though I didnt get it all done for the due date I'm still going to keep working on the rest of the project.
Read more

Project 5 8 unwraps of objects

Image
8 unwraps of an object. I found a error that the ground plane would move around and rotate to whatever I select. But I found out that in the bottom theres a button called Auto Cplane and I acidently enabled that Another error I had is that the unroll command would spread all the faces out disconected. I had a little bit of trouble making it unroll flat, but I found out you can make sure its flat by making sure your only selecting points on one poligon when you rotate. ___________________________________________________________________________________ ___________________________________________________________________________________ ___________________________________________________________________________________ ___________________________________________________________________________________ This one I did 2 different unwraps, for the one in the top right I found its faster to just copy the parts, then move and rotate with osnaps. _________________________________________________...
Read more